![]()
Also, you can use Adafruit IO for developing various IoT projects. In the ‘Choose feed’ window, click on the feed named camera_feed and click on ‘Next step’.Īfter that click on Create Block to create the image block. Now to add block click on ‘+ sign’ on the top right corner of the screen and scroll down to the image block and click on Create. To create dashboard click on the “Create Dashboard” button in the upper right corner and give name to the new dashboard like Pi Camera Dashboard. Note: For detailed description about creating a feed, follow the link.Īfter creating a feed now you need to create a ‘Dashboard’. Now after this you need to create a feed, which you can do by clicking on ‘Feed’.Ĭlick on ‘Actions’ to proceed and then click on ‘Create a New Feed’. Method 1: Stream video to Adafruit IO dashboardįor Adafruit IO setup, first sign up on Adafruit IO website by clicking on ‘Get started for Free’ at the top right corner of the screen. You can also see our other projects for interfacing Raspberry Pi with different sensors. Step 10:- If you see the command fail error, go back and check that you have enabled the camera or not and make sure the camera cable is connected firmly with the board. Step 9:- If the camera works properly, the on-board red LED of the camera will glow whenever you click as photo. Step 8:- After the reboot, test the camera to check whether its working or not by using the following command: raspistill -o cam_test.jpg In the next window, a dialog will appear asking to reboot the system, select the ‘Yes’ option. Step 7:- Now exit from this window by selecting the ‘Finish’ option. Step 6:- Confirm the selection by choosing ‘Yes’. Step 5:- Now in the next screen click on ‘Camera’. Step 4:- After this, a screen will open, and on that screen click on ‘Interfacing Options’. Go to the interfacing options using the below command: sudo raspi-config Step 3:- Now after this will need to enable the camera. Now press down on the ends of the black connector. Camera cable’s metal pads should face the metal pads inside the connector. Step 2:- To connect camera pull up on the ends of the black plastic connector and insert camera cable as shown in below image. The connector is marked with ‘CAMERA’ on the board. Step 1:- First, turn off your Pi and then locate the camera connector, a long black connector between the HDMI port and Ethernet port. To interface Pi Camera with Raspberry Pi, follow the steps below: Here, in this tutorial, we are going to demonstrate you both the methods of streaming the live video over the internet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |